PRINTABLE VIEW

Equipment needed:

  You will need our CargoChair. This platform will attach to ANY Kifaru pack for hauling massive loads
     
  The Link. This short segment of web integrates our CargoChair to your MOLLE frame.
     
How to do it :    
     
 

1. Place the Link behind (body side) your MOLLE and wedge webbing into bottom slot. Make sure both Common Loops are at lower end.

     
 

2. Wrap the 3-Bar end over the frame and thread it through the nearest Common Loop.

 
     
  3. Snug up this loop - the 3-Bar and Common Loop should lay flat against your MOLLE frame, and not hang down.
     
 

4. Thread the 3-Bar of your CargoChair through the remaining Common Loop on the Link. Repeat for other side.

     
  5. Upper Attachments.
Run the 3-Bar on your CargoChair straps through any slot on the upper portion of your MOLLE frame.
     
  Your hauler should now look like this.
     

Lash gear on with your own cordage, or add our X-Strap Kit - a quick and secure method of locking your load down. Click here for instructions.