1. with your Tarp set up, locate the large grommet on your Annex
Annex Instructions Parts list includes: - Annex - bolt for Peg & Pole setup You will need: 3 additional stakes |
|---|
1. with your Tarp set up, locate the large grommet on your Annex |
2. remove the top of your current front support (stick, Peg & Pole Kit or trek pole) and insert through this grommet. | ||
|
|
||
| 2a. Peg & Pole Kit only: use the supplied bolt and insert through the top of the Annex. | 2a. Washer should be on top. Insert bolt into the top of your Pole. | ||
|
|
||
| 3. Insert support back into the front of your Tarp. | 4. Tie off the Annex at your Tarp's two front stakes | ||
|
|
||
| 5. Stretch front of Annex out tautly and stake both sides down, using one peg | 6. Stake out 2 remaining anchors | ||
|
|
||
| 7. Remove front peg and disconnect side opposite stove jack. Reset peg. Tie off "door" at side. | 8. Add your stove, and you're all set | ||
|
|
||